Imx283 camera not recognized in TX2 NX with carrier board LI_NANO_CB

[shreyasj256]

"Internal data stream error" is thrown upon running Gstreamer, when using imx283 camera with LI_NANO_CB carrier board and Jetson Nano module

Since not finding any progress on below enquiry. I decided to shift to Jetson Nano from TX2NX. I am using Tegra version r32.3.1 I have used drivers provided by @SimonZhu and followed the same procedure as in the above mentioned post. The drivers are sucessfully loaded and video0 ,…video3 are seen in /dev folder. However I am running into problem. I am getting “i2c write failed” in dmesg if the camera is not connected on their respective ports . " tegra-vii2c 546c0000.i2c:no acknowled…

After getting the video feed from imx283 on Jetson Nano using Jetpack 4.3, I was wondering what diffrently needs to be done on TX2NX using Jetpack 4.6.1 ,so that the camera imx283 runs on it .

Any suggestions ??