Hi,
Getting into recovery mode is definitely the issue. Per the dev kit setup video, and this forum Recovery mode does not work(Jetson AGX Xavier), the board should be set in recovery mode. I was able to measure noisy voltages across the recovery button (per the linked forum discussion).
Upon trying to use SDK manager, I get the attached error message
Looking into that bashscript and running /nvautoflash.sh, I get the following
. Confirming that the Jetson is not in recovery mode.
Just running ~/nvidia/nvidia_sdk/JetPack_4.6_Linux_JETSON_AGX_XAVIER_TARGETS/Linux_for_Tegra$ sudo ./flash.sh gave the following error
I noticed an option, rcm-boot. However, when trying to run this option I get the following issue.
Any advice or suggestions would be greatly appreciated.
Thanks,
Cody