Jetson Nano Jetbot Install "create-sdcard-image-from-scratch" pytorch vision error

[jaybdub]

Hi Phreddog24,

Thanks for reaching out!

This may be the result of with a mismatch between the version of PyTorch and Torchvision. For using JetBot, the latest validated instructions are located here

https://jetbot.org/v0.4.3/software_setup/sd_card.html

If you’re interested in doing a custom setup and not using these docker containers, I would recommend following this post for installing PyTorch on Jetson

PyTorch for Jetson

Below are pre-built PyTorch pip wheel installers for Jetson Nano, TX1/TX2, Xavier, and Orin with JetPack 4.2 and newer. Download one of the PyTorch binaries from below for your version of JetPack, and see the installation instructions to run on your Jetson. These pip wheels are built for ARM aarch64 architecture, so run these commands on your Jetson (not on a host PC). You can also use the pre-built l4t-pytorch and l4t-ml container images and Dockerfiles. PyTorch pip wheels JetPack 5

PyTo…

Please let me know if this helps, or if you run into any questions / issues.

Best,
John