Jetson Nano Suddenly Shut DOWN

Robotics & Edge Computing Jetson & Embedded Systems Jetson Nano
1

I have installed Yolov5 on my Jetson nano, and whenever i tried to run the detect.py, it will run until the fusing layer, then it will shut down by itself. May I know what is the problem?

2

Hi @Jazzztin ,
Moving this to Jetson Nano Forum
Thanks

4

Hi,

Could you set the nvpmodel into the 5W mode and try it again?

$ sudo nvpmodel -m 1
$ sudo jetson_clocks

For more details, please check below topic:

Thanks.

6

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.