Jetson TX2 NX USB 3.0

Hi,
I had developed custom carrier board for TX2 NX SOM.
I have not used USB 3.0 Hub in my board. I directly take out my USB 3.0 port pins to USB 3 Type A connector. Following are the connections.

USB Type A CON                                                                                                                        SOM PINS
  VBUS           1                                                                                                                             +5V
  -D                 2                                                                                                                           USB1_D_N (115)
  +D                 3                                                                                                                           USB1_D_N (117)
  GND             4                                                                                                                                 GND
   RX-              5                                                                                                                         USBSS_TX_N[166]
   RX+              6                                                                                                                        USBSS_TX_P[168]
   GND            7                                                                                                                                  GND
   TX-              8                                                                                                                         USBSS_RX_N[161]
   TX+             9                                                                                                                          USBSS_TX_N[163]                                                                                                                 

I tried to connect USB keyboard and mouse to that port but its not working.
I checked VBUS at the connector pin it properly coming.
Shall we need to reconfigure the Port.

Sorry for the late response, is this still an issue to support? Thanks

Please refer to the TX2-NX adaptation guide in the developer guide document.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.