MCP251x not initializing in Jetson-IO

Hi
I want to link my mcp2515 can module over spi to my jetson nano (2gb). I’ve followed most of the guides, and I keep getting no results for the mcp2515-controller when I run jetson-io. I’m new to kernal and device trees but a lot of the guides make sense, just don’t seem to work for me.

I’ve connected the board to the jetson, and have gotten as far as dropping the generated dtbo from mcp251x.dts into the boot directory, but from there nothing seems to change in jetson-io to allow me to configure the spi to use the can controller configuration.

Thank you for your help

Please check below thread to see if can help: Unofficial Guide to using the MCP2515 can module on the Jetson Nano 2GB

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.