on our custom-designed carrier board, we modified the DP signals in the pinmux table to HDMI signals. However, there is no HDMI output after re-flashing the firmware.
Could you advise which critical steps we may have omitted for the above scenarios?
Hello @1746151250!
Based on the title and content of your topic, it looks like it may receive better visibility and feedback in a different category. We took the liberty of moving it for you.
If this was an incorrect assessment, please send me a direct message.
Disclaimer: this moderation suggestion and message were generated with AI assistance.
please refer to p3509 board config in your BSP directory Linux_for_Tegra. That file has the HDMI change required.