Hello. As the J12 serial THS0 port only has UART1, I’m trying to use J14’s UART2 RXD TXD ports for higher speed. Thing is, I’m unable to get any communication out of it connected to the host PC, despite renaming the serial devices as THS0, THS1 or THS4 in minicom which was then tested in putty. The …

you may also check below topics as see-also. thanks [image] NX change console to other uart Jetson Xavier NX Instead of default ttyTCU0. Is there any way to change console-port to other uart port ? Since I’ve tried to modify tegra194-p3668-common.dtsi and cboot source…

Trouble using J14

Robotics & Edge Computing Jetson & Embedded Systems Jetson Xavier NX

JerryChang February 19, 2021, 2:44am 5

you may also check below topics as see-also.
thanks

Topic		Replies	Views
Use UART Pins on Jetson Xavier NX J14 Jetson Xavier NX uart	13	5206	October 18, 2021
Using more UARTs for serial communication on DevKit Jetson Xavier NX gpio , uart	11	4041	July 7, 2021
How to change the NX debug UART/ttyTHS1 to a general UART function? Jetson Xavier NX uart	11	4149	October 18, 2021
How to use uart on Xavier NX Jetson Xavier NX gpio , uart	2	4627	October 18, 2021
Jetson Xavier NX how to use the UART J14 port Jetson Xavier NX uart , linux	12	6221	September 22, 2021
Xavier-nx: How to change UART port: /dev/ttyTCU0 as normal UART function Jetson Xavier NX kernel , uart	11	445	June 17, 2024
NX2 TX UART on debug console port Jetson TX2 uart	4	1489	December 9, 2022
How to disable TCU0 UART port from being used for Serial console Jetson Xavier NX uart , board-design	2	1901	October 18, 2021
Cannot configure UART port properties Jetson Xavier NX hw , reflash , kernel , ubuntu , uart , device-tree	2	927	October 27, 2022
how to change uart1(tegra signal ) to drive to uart 2 module pin instead of to uart 0 module pin in tx2/i Jetson TX2	6	794	October 18, 2021

Trouble using J14

Related topics