Usb 3.0 compliance test with hub

Autonomous Machines Jetson & Embedded Systems Jetson Xavier NX
1

Hi

We are testing USB 3.0 compliance test with NX EVB board and get really low signal.

According the link below, testing USB with needs a code to set hub into test mode.
Does the code for Nano work on NX?
If not, could we get the code for NX too.

Thank you,

2

For any compliance that is going through an external hub, please contact the hub vendor for the tool.

3

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.