Hi, @Manikanta, could you help with similar issue with QCNFA335?
[ 6.031485] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 6.060275] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 6.161363] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 6.182632] mc-err: (0) csw_afiw: EMEM address decode error
[ 6.188332] mc-err: status = 0x20011031; addr = 0x65e17060
[ 6.194056] mc-err: secure: no, access-type: write, SMMU fault: none
[ 6.204215] mc-err: (0) csw_afiw: EMEM address decode error
[ 6.209878] mc-err: status = 0x20011031; addr = 0x65e18060
[ 6.215612] mc-err: secure: no, access-type: write, SMMU fault: none
[ 6.237889] mc-err: (0) csw_afiw: EMEM address decode error
[ 6.243527] mc-err: status = 0x20011031; addr = 0x65e19060
[ 6.249255] mc-err: secure: no, access-type: write, SMMU fault: none
[ 6.273950] mc-err: (0) csr_afir: EMEM address decode error
[ 6.279582] mc-err: status = 0x2000000e; addr = 0x5d9ffe00
[ 6.285328] mc-err: secure: no, access-type: read, SMMU fault: none
[ 6.303306] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 6.303359] Bluetooth: BNEP socket layer initialized
[ 6.312131] mc-err: Too many MC errors; throttling prints
I tried your solution here and recompile the kernel but it didn’t work.
This seem also has been reported here
Additional info: the first time the image booted and I had to setup the wifi connection in the wizard, it worked. But after it reboots, that error above is shown in dmesg.