Hello I’m using “panel-s-wuxga-8-0.dtsi” to send DSI video to a FPGA. But it is seems to be configured as 4-lane ganged mode. I need DSI in non-ganged mode. When I commented these lines : //nvidia,dsi-ganged-type = <TEGRA_DSI_GANGED_SYMMETRIC_LEFT_RIGHT>; //nvidia,dsi-ganged-swap-links = <1>; /…

Yes. This is result : tegradc 15200000.nvdisplay: dsi: video fifo underflow. Resetting flag Of course, this change caused to have a signal on all four lanes of DSI-A. But apparently these signals are not healthy video. Maybe I’m making a mistake in receiving the video with fpga. I will be here aga…

DSI in non-ganged mode

Robotics & Edge Computing Jetson & Embedded Systems Jetson TX2

WayneWWW July 28, 2020, 5:15am 10

To know the dts properties, you could refer to below page.

Topic		Replies	Views
DSI ganged mode Jetson TX2 dsi-display	5	823	October 18, 2021
TX2, DSI Video Output, Ganged Mode Left/Right, Device Tree Configuration Questions. Jetson TX2	16	2989	October 18, 2021
Two DSI monitors Jetson TX2 dsi-display	18	873	October 18, 2021
Two DSI port, 4lane/port Jetson TX2 hw , kernel , board-design	4	397	October 18, 2021
Two DSI panels displays on TX2 with Jetpack 3.2.1? Jetson TX2	7	1770	July 26, 2018
Turn off HDMI programmatically Jetson TX2	60	4749	December 19, 2018
Problems enabling DSI on TX2 Jetson TX2	12	1736	October 18, 2021
Question : How to config 2 lanes DSI output Jetson TX2	2	590	October 18, 2021
How can drive SN65DIS85? Jetson Nano kernel , dsi-display	20	2996	August 4, 2021
TX2 DSI Ports Jetson TX2	11	1570	October 18, 2021

DSI in non-ganged mode

Related topics