Hi teams I use the agx xavier device, and L4T is R32 (release), REVISION: 5.1, GCID: 26202423, BOARD: t186ref, EABI: aarch64 I want to configure SPI2 as a slave mode device in Xavier. I want to know the configuration in the dt and pinmux settings. And which addree is SPI 's address, is 0xc260000?…

You can try use GPIO as CS. Have reference to below relative topic. [image] TX2 R28.2 SPI CS-GPIO issue Jetson TX2 Could you try if remove the cs0 to check if the pin working correct? cs-gpios = <&tegra_main_gpio TEGRA_MAIN_GPIO(X, 6)>, <…

How to configure SPI2 as a slave?

Robotics & Edge Computing Jetson & Embedded Systems Jetson AGX Xavier

ShaneCCC July 22, 2021, 3:43am 6

Have reference to below topic for Xavier.

Topic		Replies	Views
How to set to spi slave mode Jetson Xavier NX spi	47	11341	October 18, 2021
Why SPI@c260000 in slave mode keep reporting error on AGX Xavier? Jetson AGX Xavier spi	8	930	August 12, 2021
SPI1 not work on Xavier Jetson AGX Xavier	47	7778	October 18, 2021
Xavier SPI in slave mode keep reporting CS_INACTIVE error Jetson AGX Xavier spi	41	1732	April 11, 2022
Spi3 connect nor flash Jetson Xavier NX spi	29	1911	December 2, 2021
Enabling SPI Nodes on Xavier-Nx Jetson Xavier NX spi , board-design	11	3866	August 25, 2021
Master-Slave Communication Between Two Jetson Nano over SPI Jetson Nano spi , python	56	3874	August 29, 2022
How to enable spi0,spi1 and spi2 on jetson tx2 EVK Jetson TX2 spi	60	2068	October 18, 2021
How to configure SPI1 as a slave? Jetson AGX Xavier spi	13	1245	October 18, 2021
Switching SPI to slave mode Jetson Orin Nano spi , nvbugs	20	93	March 6, 2025

How to configure SPI2 as a slave?

Related topics