jetson Nano and ZED camera

I have installed the ZED camera SDK on the jetson nano but when i start the ZED depth viewer, after 1s, the nano turns off itself.

I have tried the camera on a host PC and updated the camera firmware but still the same issue.
I can open the ZED explorer but the depth viewer makes the nano off…

Does someone know why this issue happen?

Please help. Thank you in advance

Hi schoninger,

We didn’t run any test with ZED camera yet, thus don’t know why it can’t work, but you could refer to below topic if can help:


ZED requieres a lot of computation, so verify that your power supply is going to give you enough. I recommend to use MICRO USB 5V-3.5A