Jetson Nano Camera connector defective

Yesterday I unpacked my Jetson Nano and loaded the disk image on a 64 GB card went through initial setup on first time booting. I then powered it down to install a raspberry pi camera. The little clasp and it came off rather than just lifting up. Part of the mechanism must still be closed because even with it off the camera ribbon will not go into the slot. How do I go about getting a replacement board sent to me?

Thanks,

Kyle

Hi Kyle, see this link for the RMA procedure:

https://developer.nvidia.com/embedded/faq#rma-process

Also here is the part used for the camera connector: https://www.mouser.de/ProductDetail/TE-Connectivity-AMP/1-1734248-5?qs=GQ3BsEl46pkrMd7Fg9TUQQ%3D%3D