LI IMX219 MIPI No Camera Found on Jetson Nano

Autonomous Machines Jetson & Embedded Systems Jetson Nano
17

I’m facing similar problem, but in my case the camera port-0 is not working but camera port-1 working fine. two cameras were working earlier. But due to a crash I re flashed the sd card and now one camera is not wrking. similarly the board will shutdown abruptly.
board used: Jetson nano B01

  1. I have two cameras (sony IMX219 sensors).

  2. Both Camera modules are working in port-1

  3. I also checked the connection (Ribbon cables) and could not observe any connection issue.

  4. I got below output .when i executed the command “dmesg | grep -i imx219”
    image

  5. Also got low error message when tried to run the camera with the command “nvgstcapture-1.0 --camsrc=0”
    Encoder null, cannot set bitrate!
    Encoder Profile = High
    Runtime USB Camera Commands:

Help : ‘h’
Quit : ‘q’
Set Capture Mode:
mo:
(1): image
(2): video
Get Capture Mode:
gmo
Capture: enter ‘j’ OR
followed by a timer (e.g., jx5000, capture after 5 seconds) OR
followed by multishot count (e.g., j:6, capture 6 images)
timer/multihot values are optional, capture defaults to single shot with timer=0s
Start Recording : enter ‘1’
Stop Recording : enter ‘0’
Set Preview Resolution:
pcr: e.g., pcr:2
(0) : 176x144
(1) : 320x240
(2) : 640x480
(3) : 1280x720
(4) : 1920x1080
NOTE: Preview/Encode resolution will be same as Capture resolution for USB-Camera
Get Preview Resolution:
gpcr
Get Image Capture Resolution:
gicr
Get Video Capture Resolution:
gvcr
Set Capture Device Node:
cdn: e.g., cdn:0
(0): /dev/video0
(1): /dev/video1
(2): /dev/video2
Get Capture Device Node:
gcdn

Runtime encoder configuration options:

Set Encoding Bit-rate(in bytes):
br: e.g., br:4000000
Get Encoding Bit-rate(in bytes):
gbr
Set Encoding Profile(only for H.264):
ep: e.g., ep:1
(0): Baseline
(1): Main
(2): High
Get Encoding Profile(only for H.264):
gep
Force IDR Frame on video Encoder(only for H.264):
Enter ‘f’

** Message: 18:23:08.894: main:4670 iterating capture loop …
ERROR on bus: by /GstPipeline:capture_native_pipeline/GstBin:cap_bin/GstV4l2Src:v4l2src0: Internal data stream error.
debug info:
gstbasesrc.c(3055): gst_base_src_loop (): /GstPipeline:capture_native_pipeline/GstBin:cap_bin/GstV4l2Src:v4l2src0:
streaming stopped, reason not-negotiated (-4)
** Message: 18:23:09.000: main:4680 Capture completed
** Message: 18:23:09.009: main:4729 Camera application will now exit

  1. Later I tried below steps based the thread: probing issue
  2. disconnected power jack
  3. Reconnected the camera
  4. Rebooted the board
    Still no luck