Mipi csi

I am considering a carrier board that can connect three 2-lane MIPI cameras to a jetson orin nano.

I checked the Pin_Descriptions.xlsx and confirmed that CSI1_CLK_N is RSVD.

In this case, would it be better to avoid CSI1 and use CSI0,2,3?

I would appreciate your advice.

I understand that the Jetson orin nano can connect four 2-lane MIPI cameras.

Therefore, I understand that there is no problem using CSI1_CLK_N and CSI1_CLK_P to use MIPI cameras, but is there anything to note?

If possible, I would be grateful to know more about the reasons for RSVD.


No other thing to note, just follow the Design Guide in DLC.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.