i am using mach03L evaluation board with 1 lane,
the clock do not present any error,
but i get syncpt timeout error .
q1: is this may be becuase MIPI calibration does not take place ?
q2: must it do mipi calibration ?
q3: the lattice produce the clock and data signal and dmesg show no error, but only syncpt error. How to debug next ?
q4: the i2c is removed in the driver.
q5: it is RAW 14 format, is it always considered as 24 bytes ?
q6: is i2c is essential part, or i can preconfig directly the vi2.c file with the constant resolution and size ?
q7: what would be the very minimum values to set the vi2.c to run and image , without i2c ?