Orin no longer turning on after flash attempt

Robotics & Edge Computing Jetson Systems Jetson AGX Orin
1

I was trying to flash an AGX Orin 64gb developer kit with Jetpack 6.2.2. During the process I recieved the following popup:

IMG_7752
IMG_7752574×581 45.1 KB

I followed its instructions, but when I reconnected the orin to power, it would no longer boot, either in normal or recovery mode. In the aftermath of the incident, the edge of the board smelled burnt to me, but it may have just been a stress-born hallucination. To both myself and my electrical engineer colleague, the board still looks undamaged.

Now, when i try to boot it, I can hear a faint clicking coming from the board from where I would normally hear the loud click that accompanies the power light turning on.

I’m looking for troubleshooting tips to try and “revive” the orin, or a way to determine if this was caused by human error or a preexisting defect.

Also, If it helps, I was flashing from an ubuntu 22.04.5 VM running on a windows 11 host.

Edit: after scouring these forums, the symptoms being experienced here are the same as in Replacement required for Jetson AGX Orin Dev Kit

4

Hi,

Thus, Could you detect the AGX Orin using lsusb commands?

Please provide the result for us to review.

Thanks

5

I could not. I didn’t save the results when I performed it, and it’s already been taken off my hands by my organization. I’ve been given another, and will update the thread if the same issues occur.