Orin NX 16 GB not booting after successful flashing

Robotics & Edge Computing Jetson & Embedded Systems Jetson Orin NX
1

Hi,

We have successfully flashed 2 Orin NX units and flashing is successfull.

But the units are not booting after flashing.

Any idea what might be the root cause?

Note: We are using PHMC 8051 micro controller to the control the power sequencing and give a GO AHEAD signal for powering on only , if we receive some signal from Jetson Orin NX module.

Thanks,
Nagesh R

2

Hi,

You should share necessary information. You have been this forum for 2 years… you should know sharing a log is the basic…

Nobody would know why a board cannot boot with just such little information…

3

Sorry. I told the same to my manager but he was insisting to post a thread.

Since the hardware setup is not ready for taking Console log, will try to get the log once setup is ready.

Thanks

4

The issue was with the customized carrier board it seems with shortage of some regulator, etc… Now its booting fine.

1 Like
5

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.