Hi, I’m trying to update our system, switching from Jetpack 3.2.x to Jetpack 4.5.1. I’m having issues ingesting video with our ported driver though. We ingest video via an FPGA, which we have to tell (from userspace) to start sending video via CSI. The FPGA waits for the start of an external video…

There is no update from you for a period, assuming this is not an issue any more. Hence we are closing this topic. If need further support, please open a new one. Thanks Hi Ratbert , Any update? Could you read those REG back to confirm it was masked.

TX2 CSI Capture with Jetpack 4.5.1

Robotics & Edge Computing Jetson & Embedded Systems Jetson TX2

ShaneCCC April 7, 2021, 4:14am 3

Have apply below patch to try.

Topic		Replies	Views
Custom Carrier TX2 CSI Video problems Jetson TX2	19	1709	November 5, 2018
CSI Camera Custom Driver Errors Jetson TX2	9	2003	October 18, 2021
Porting i2c camera driver 4.4->4.9 Jetson TX2 camera	18	1460	December 10, 2020
TC3587439 in TX2 can not grab video stream. Jetson TX2	7	723	October 18, 2021
Tx2 CSI grab data from FPGA without I2c Jetson TX2	16	1243	October 18, 2021
TX2 CSI 4-lane with L4T r28.2 Jetson TX2	17	1840	October 18, 2021
TC358743 MIPI CSI issue Jetson TX2 camera	7	1023	September 19, 2021
Hdmitomipi ,v4l2-ctl report error Jetson Xavier NX camera	21	1094	December 1, 2021
Can't grab 3840x2160 mipi-csi video stream. Jetson TX2	10	879	November 7, 2019
Same camera on same carrier board, TX1 works fine,but TX2 can't open camera Jetson TX2	17	1650	October 18, 2021

TX2 CSI Capture with Jetpack 4.5.1

Related topics