Undesired horizontal lines and broken pixels on the lcd

Hello

I am using jetson nano.
For display I have TFP401 HDMI/DVI Decoder to 40-Pin TTL Breakout - With Touch : ID 2219 : $29.95 : Adafruit Industries, Unique & fun DIY electronics and kits this hdmi decoder product to drive the this LCD https://www.digikey.com/en/products/detail/amulet-technologies-llc/AM043NBG01/11611167

I am able to run the lcd but I see some horizontal lines and some pixels are not correct in verticaly.

Like this:
lines

I changed the edid file to adjust the size to 480x272. Sreen fits but I could not solve this undesired behaviour.

To understand the problem is hardware related or not, I connected the same system to raspberry pi 4 and I did not see any lines or different behaviours.

What can be the issue here ? How should I debug the problem.

Thank you very much.

There is no update from you for a period, assuming this is not an issue any more.
Hence we are closing this topic. If need further support, please open a new one.
Thanks

What is the exact interface that is connected on jetson side for this panel?

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.