Hi, I’m able to perform can loopback and can communication between my orin and vector canoe tool but I need to perform can wake up function.
I tried to open candump in my orin and send messages from the canoe tool and put my orin board into suspend mode but it is not working.
What to do ?

Hi srivathsan.p,

Are you working with @pritamdinkar.waghmode?
If so, let just discuss the same issue on that topic ( CAN_WAKE in AGX Orin - Jetson & Embedded Systems / Jetson AGX Orin - NVIDIA Developer Forums)

No I’m not working with anyone

You could also refer to my reply in the following thread.
CAN_WAKE in AGX Orin - #6 by KevinFFF

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.