Configuring the operation mode of BlueField ports

Hi,

As I got from the documents, there are two modes of operation on Bluefield, the separated mode and the embedded mode. Also, we can configure each port independently. However, whenever I change the mode of each port, the configuration is applied to the other port as well. In other words, I need to configure one port to work in embedded mode, and the other to work in separated mode. I did the instruction based on this link.

Hello Hesam,

Thanks for your question.

Configuring separated/embedded mode on the Bliefield-2 card is not supported per physical port, but per Bliefield-2 card only.

I’ve checked the user guide you used, and it will be corrected soon accordingly.

Best Regards,

Anatoly