ERROR: Card did not respond to voltage select!, after flashing Jetson Nano pinmux config

Autonomous Machines Jetson & Embedded Systems Jetson Nano
1

FOllowing the 40 pin expension header config. After flashing the nano, i got this problem and i couldn’t boot my board. The boot stuck at this. What should I do next?. I want to change the pinmux to enable PWM on PIN 32,33.

2

Is this topic same to below one?

[url]Can't get Jetson Nano to boot with custom pinmux configuration per Nvidia instructions - Jetson Nano - NVIDIA Developer Forums

If so, I will track this issue there. Please come and join our discussion. Thanks.