My Jetson Orix can not normally start. It shows some commands on the screen and then stops showing anything. What should I do
Hi @linshen_liu
Could you please share the serial console log? You can get it by following the instructions at NVIDIA Jetson Orin AGX - In Board - Getting in Board - Serial Console
Regards!
Eduardo Salazar
Embedded SW Engineer at RidgeRun
Contact us: support@ridgerun.com
Developers wiki: https://developer.ridgerun.com/
Website: www.ridgerun.com
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.