Jetbot - No OLED, No Motors

Robotics & Edge Computing Jetson & Embedded Systems Jetson Nano
1

Hello,

I’m pretty sure I failed on the soldering of all the connections on the motor controller board. The JetBot boots and I can get in to the Jupyter Notebook. Motors don’t run, OLED does not light up, no blinking lights. Other than ordering a replacement (inexpensive) motor controller board, should I try anything else? TIA.

2

Forgot the output of this command

jetbot@jetbot:~$ i2cdetect -y 2
Warning: Can’t use SMBus Quick Write command, will skip some addresses
0 1 2 3 4 5 6 7 8 9 a b c d e f
00:
10:
20:
30: – – – – – – – –
40:
50: 50 – – – – – – 57 – – – – – – – –
60:
70: