Jetson AGX Xavier will struck in booting and will not go to configure screen

Hi,

I am using Jetson AGX Xavier module (tried both 16GB,8GB modules) on a customised carrier board which is based on AGX Xavier OEM design guide and Using a custom built BSP based on L4T 32.4.3.

I tried to Flash the image on module and it is successful but at the first boot immediately after flash, it is not booting to the desktop i mean the configuration options are not coming it struct in this stage for long time more than 45 minutes… keeps hangng here

If I reboot the system, then It goes to user configuration screen shown below immediately and works normally then after, why it does not go to the configuration of desktop in the first boot?
config_screen

hello venkatraman.bhat,

it’s waiting for your feedback,
you may setup peripherals and please complete system configuration.
thanks

1 Like