Jetson Nano Boot Failed

[breyner.posso]

Hi! I’m using a 4GB jetson nano dev kit with a 32GB microSD. I downloaded the jetpack suggested in this guide:

Getting Started With Jetson Nano Developer Kit

My jetson was working but today I got this error message while booting:

tegradc tegradc.1: dpd enable lookup fail:-19
imx219 7-0010: imx219_board_setup: error during i2c read probe (-121)
imx219 7-0010: board setup failed
imx219 8-0010: imx219_board_setup: error during i2c read probe (-121)
imx219 7-0010: board setup failed
not writing trough dangling symlink ‘etc/resolv.conf’
cgroup: cgroup2: unknown option “nsdelegate”
using random self ethernet address
using random host ethernet address
random: crng init done
random: 7 random warning(s) missed due to ratelimiting
using random self ethernet address
using random host ethernet address

I really don’t know what to do. Could someone help me with this issue?

Thanks!

[kayccc]

Please refer to below topic to see if can help: Debug tips when you hit any issue (fail to boot/ keep reboot …etc) - Jetson & Embedded Systems / Jetson Nano - NVIDIA Developer Forums

[KevinFFF]

Hi breyner.posso,

There’s a thread about the error as yours, please refer to it
not writing trough dangling symlink ‘etc/resolv.conf’
Jetson Nano 2GB error cp: not writing through dangling symlink 'etc/resolv.conf' - #4 by Dmitry_F

Or You might need to re-flash the board through SDK Manager:
Install Jetson Software with SDK Manager :: NVIDIA SDK Manager Documentation