Jetson not powering on

I’ve been using the Jetson on and off for a while now. I put it away for about 3 weeks due to exams, and now when I try to power it on, it doesn’t seem to work.

Plugging in the adapter, both with and without peripherals powers on the fan and power LED for ~0.5-1s before everything goes off again.

I’m using the power adapter that was supplied with the board.

Anyone faced this in the past/have a fix?

Did you test pressing power and reset buttons? Anything in the serial log?

I did try that. It just powers on for half a second again before going off. Nothing on the serial log

Do you have a volt meter? You might check the output of the power supply before and during power up. Should remain reasonably constant before/during/after failure.