i was connecting arducam imx 477 camera module to jetson orin nano developer kit ,when systems boot up automatically camera ribbon burn , this was my 3rd wire i face this problem.
i followed instruction from jetsonhacks youtube channel.
this is video when wire was burn
camera_ribbon_burn.zip (15.5 MB)
hello user12734,
we don’t see such failure, may I know which 15-22 pin camera ribbon you’re using?
hello sir,
i am using 22-22pin camera ribbon ,because arducam imx 477 camera csi pin support 22 pin
this is link where i bought:
https://www.amazon.in/gp/product/B09R6RF2TW/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1
Hi, you need to check the pin mapping of the connector of your CSI sensor board to see if it can meet below pin mapping of camera connector of Jetson Orin nano carrier. You can find the devkit carrier pin mapping in Jetson Orin Nano Developer Kit Carrier Board Specification and in the P3768_A04 schematic in Jetson Orin Nano Developer Kit Carrier Board Reference Design Files
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.
