Orin camera hardware connect length

[syan]

Hi All, I have some questions as below,
Hardware connect length should be the same?

In DPHY x2 lane,
1.) Does data1(CSI0_D0P/N and CSI0_D1P/N) length should be the same?
2.) Does data1(CSI0_D0P/N and CSI0_D1P/N) and clock1(CSI0_CLK_P/N) length should be the same?
3.) In different camera, data1(CSI0_D0P/N and CSI0_D1P/N) and data2(CSI4_D0P/N and CSI4_D1P/N) length should be the same?

.
In DPHY x4 lane,
1.) Does data1-1(CSI0_D0P/N and CSI0_D1P/N) and data1-2(CSI1_D0P/N and CSI1_D1P/N) length should be the same?
2.) If Does data1-1 and clock1 length should be the same?
3.) In different camera, data1-1 and data2-1 length should be the same?

.
In CPHY x2 lane,
1.) Does data1-1(CSI0_D0P/N) and data1-2(CSI1_D1P/N) length should be the same?
2.) If Does data1-1 and clock1-1 length should be the same?
3.) In different camera, data1-1 and data2-1 length should be the same?

Thanks,
Syan.

[Trumany]

Just follow Table 10-6. MIPI CSI D-PHY Interface Signal Routing Requirements to make your routing design.