Hi,
We are doing compliance test. Could you provide “Tuning and Compliance Guide” for Thor ?
Thanks.
BR//
The Tuning and Compliance Guide has been renamed for Thor. Please refer to Jetson Thor Series Modules I/O Verification Guide.
I follow the guide to put USB in compliance mode.
But I can’t modify the register by “devmem2 0xa80aa10440 w 0x10340”
The readback value is not as expected.
Hi,
Please refer to below note in tuning guide. Readback value is not expected.
Hi, Wayne
Also the same question. We followed the instructions, after step 11, the read value is also not 0x10340. and we still can’t perform the compliance test. No expected signals show.
Have you verified that you are programming the port that you are probing? From section 2.2.2 of the Jetson Thor Series Modules I/O Verification Guide:
