Hi, I’m running tx2 jetpack4.2 with our carrier board,I got kernel crash when system start. log: tx2-crash.txt (40.3 KB) could someone please tell me what happened…

PMIC is in the module, you can test the module with good carrier board to make sure if the module is good. If it is a issue of this custom carrier board only, you should check with your hardware engineer to investigate since it is hard to get result from software side.

TX2 kernel crash when power up

Robotics & Edge Computing Jetson & Embedded Systems Jetson TX2

JerryChang April 22, 2021, 1:52pm 7

hello suchb,

you may refer to Topic 169608 for an example of the definition in device tree to indicate the regulator names and its voltage.
thanks

Topic		Replies	Views
The TX2 Module suddenly crashes and black screen after being turned on for many days Jetson TX2	7	790	October 18, 2021
The Tx2 module suddenly crashed and the screen went black after being turned on on the carrier board designed by ourselves for several days Jetson TX2 boot , board-design	2	350	October 18, 2021
Tx2 desktop aways crash on custom board Jetson TX2 board-design	9	655	October 18, 2021
dts consult about a carrier board without the HDMI circuit Jetson TX2	4	1347	October 18, 2021
TX1 Kernel keeps throwing I2C-3 error during boot-up Jetson TX1	7	3049	November 23, 2017
TX2i boot failure Jetson TX2 boot	18	924	October 18, 2021
Tx2自动上电不能启动 Jetson TX2 kernel	12	1351	October 18, 2021
TX2 Fails to Power ON (Suspected CPU Issue) Jetson TX2	6	504	October 18, 2021
TX1 does not power up Jetson TX1	17	2664	October 18, 2021
Jetson TX2 can not into recovery mode Jetson TX2 boot , reflash	10	1974	October 10, 2021

TX2 kernel crash when power up

Related topics