Xavier NX Jetpack 4.6.2 cannot display after completing system configuration

I’m using the xavier nx module with custom carrier boards. And i flash the Jetpack 4.6.2 to the module. I can see the system configuration through the GUI at first, but after i completed the configuration, the screen suddenly went black. The problem still exists even I reflash it for many times.
Here’s the Xorg.0.log.
Xorg.0.log (14.7 KB)
Please give some suggetions, thanks!

There is no update from you for a period, assuming this is not an issue any more.
Hence we are closing this topic. If need further support, please open a new one.

Please check the uart console and see if the board can boot int o system after doing configuration or not.

If it can, please share us the dmesg.