Can't detect camera on i2c with i2cdetect

Robotics & Edge Computing Jetson & Embedded Systems Jetson Nano
1

Hi!
I’ve just connected mipi/sci cameras to Jetson nano B01 (R 32, revision 6.1) and unable to detect anything on i2c.
Here how I’am going to do it:

i2cdetect -y -r 0

 0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f

00: – – – – – – – – – – – – –
10: – – – – – – – – – – – – – – – –
20: – – – – – – – – – – – – – – – –
30: – – – – – – – – – – – – – – – –
40: – – – – – – – – – – – – – – – –
50: – – – – – – – – – – – – – – – –
60: – – – – – – – – – – – – – – – –
70: – – – – – – – –

i2cdetect -y -r 1

 0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f

00: – – – – – – – – – – – – –
10: – – – – – – – – – – – – – – – –
20: – – – – – – – – – – – – – – – –
30: – – – – – – – – – – – – – – – –
40: – – – – – – – – – – – – – – – –
50: – – – – – – – – – – – – – – – –
60: – – – – – – – – – – – – – – – –
70: – – – – – – – –
Both cameras are working well with raspberry pi board.
My questions are:

  • do I need to power on MIPI/CSI ? How?
  • maybe I have to use dedicated power supply instead of micro usb power supply in order to use mipi/csi cameras?
  • some other suggestions.

Best regards

3

You need check your HW if need any power enable for your sensor design.

6

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.