Clarify the MCU control logic in Xavier NX develop board

Hi Guys
I can’t use the EFM8SB10F2G in my custom carrier board for TX2 NX module, but i will use another brand MCU to control the power on and off,
could you let me know the EFM8SB10F2G how to control the power sequence in “Auto on” and “button on” mode, then i can make the firmware to my own MCU by ourselves.


Best Wishes,

Please refer to the TX2 NX Design Guide in DLC for power sequence.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.