Jetson Nano Developer B01 - jetpack 4.4 /4.5 + imx477 (arducam 12,3)

Hey, I tried several ways to install drivers for the imx477 camera,

Raspberry Pi HQ camera IMX477 Driver | Linux driver for Jetson | RidgeRun - recommended way
https://www.arducam.com/docs/camera-for-jetson-nano/mipi-camera-modules-for-jetson-nano/driver-installation/ -automatic way

for the most part after rebooting Jetson did not start and I had to reinstall the system. There is a proven way to install their drivers for jetpack 4.4 and / or 4.5?

Please check the kernel message to check after install the driver.

You can download the official release driver from below link.

https://developer.nvidia.com/rpi-imx477-support-nano-2gb-325

126 / 5000

Wyniki tłumaczenia

After installing the drivers and resetting the jetson, it does not turn on. Only the nvidia logo is displayed and I have to reload the system

Did you have HW rework as the wiki page?

The Raspberry Pi HQ camera module requires a hardware modification in order to work with Jetson Platforms. Both Jetson Nano and Jetson Xavier NX provides 1.8V for reset GPIO in the camera interface, but the camera module requires 3.3V.