Good morning,
I have a question regarding the Jetson Nano Developer kit.
I have some kits on hand and some of them won’t boot. I inferred that the module containing the processor is broken, as replacing this module with a working one, the whole board starts up. I doubt that it was powered with a current greater than that indicated. Is there any possibility of verifying that this is indeed the problem?
You can firstly dump uart log from your board. If this is power issue, then nothing shall be shown. But if there is something shown up but you cannot boot up, then flash these modules with sdkmanager.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.