In my design I’m not using all the pins.
Some pins I left unconnected.
At the user manuel it doen’t write if it’s input or output or is there any pullup at the AGX.
For example F6, H54, J59,H57 etc.
Do I need to add pullup on my board?
No need. Please refer to the chapter “Unused MPIO Interfaces” and “Unused SFIO Interface Pins” in Design Guide for detail.
This chapter helped me a lot.
I still have few pins that not meantioned in the chapter.
L47, B10, K52
Keep them unconnected.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.