Get checksum error after using etcher to flash image to sd drive for jetson nano

Getting checksum errors when using etcher to flash to sd drive. Have tried using windows x64 version and Linux x64 version of the program. Also have done multiple downloads of the image. AM using the r32.1-2019-03-18 image. Any ideas or suggestions?

Could you paste the error message here? Do you have other sd card to test?

Am in process of acquiring another one, smaller (first was 512GB). New one will be 64GB. Will post error if occurs again or close thread if it doesn’t.

Problem was the SD Card, while it was 10x it was not UHS-1 - so didn’t work. New one did. Closing this topic.