How to set 40GPIO in jetson nano?how to use socketCAN?

1,I wang to use CAN bus MCP2515+SN65xxx WAVESHARE board

2,when i use this cmd ,is bad!
sudo /opt/nvidia/jetson-io/
He didn’t jump out of the GPIO setting page, just flashed by.
i dont know what happen?

3,how to use this PCB CAN as SocketCAN?


hello 434379124 ,

is it Nano with internal eMMC, which is production modules?
if yes, Jetson-IO doesn’t support with it, please have pinmux spreadsheet configuration to update board configuration.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.