Hello ,I am a new jetson learner.
When I try to run command " $ sudo /opt/nvidia/jetson-io/jetson-io.py " to configure my jetson pins,I got this:
this command can run but there is no option of 40-pin configurations like the guide online
Could anybody give me a help ? I have searched this question online but I got nothing helpful
my jetpack version is 4.6 and l4t version is 32.6.1
1 Like
Hi,
Do you use Nano module with SD card slot? The script supports this module. Nano module with emmc is not supported.
1 Like
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.