Hello all,
I’m trying to finish the setup for installation for my Jetson NVIDIA Nani and since i want to use an older version (4.6.2) I was told I need to flash/reset the Nano and the research is confusing me… I’m not sure if I can do a hard reset with one pin and a ground or if I need a SD card? I’m definitely new to it and need guidance… I got it on Amazon, and any help would be appreciated.
“Brand: WayPonDEV
Jetson Nano 4GB Developer Kit with 16GB eMMC, Based on N-VI-DIA Jetson Nano 4GB SoM Module, Sub Kit Nano B01 for AI AI Robotics Machine Learning (Heat Sink Version)”
Hi,
Since it is a custom carrier board, please reach out the WayPonDEV vendor to get the customized bsp.
Thanks
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.