Hello, we are using the T5000 on a custom-designed carrier board (not official dev kit). We are using Windows+NVIDIA SDK Manager,+WSL to flash JetPack and the system image, but an error occurs during the flashing process to the Jetson Linux flash memory. 22:14:47 ERROR: Flash Jetson Linux - flash: …

Hi, Please refer to the guide: Linux_for_Tegra/bootloader/tegra234-mb2-bct-common.dtsi - Jetson AGX Orin... This section provides information about the MB2 configuration changes. Thanks

Hello, we made the modifications according to the instructions in the link you provided, but the same error still occurs after the changes were made. [caea9c1be4741958b139f85603fcf23] [236e6ba8bf163d30ab32762cf4cace2]

Thank you for your reply. Our carrier board design includes an EEPROM.

This might work. Adjust to your baseboard reality. sudo BOARDID=3834 FAB=000 BOARDSKU=0008 CHIP_SKU="00:00:00:A0" \ ./l4t_initrd_flash.sh \ --external-device nvme0n1p1 \ -c ./tools/kernel_flash/flash_l4t_t264_nvme.xml \ --showlogs \ jetson-agx-thor-devkit internal

Thank you for your reply. How exactly should I modify my BOARDID? Where can I find these specific parameters? I noticed some information in the guide, but I’m not sure if it’s relevant. [image]

Hi, Please run below commands under the Linux_for_Tegra sudo ./l4t_initrd_flash.sh --erase-all jetson-agx-thor-devkit internal And provide the serial log for us to review. [image] NVIDIA Jetson AGX Thor - Accessing the Board via Serial Console Explore in-depth developer resources, set…

Hello, here is the log from running sudo ./l4t_initrd_flash.sh --erase-all jetson-agx-thor-devkit internal. I have also noticed that other developers in the community have encountered similar issues. [image] jetpack7.1,T5000,eeprom,flash failed Jetson Thor i…

Thank you for your reply. I used your commands to flash the device, but encountered a different error. However, I think it might have had some effect; normally, the fan doesn’t spin in recovery mode, but after using your commands—even though an error occurred—the fan did start spinning. [a256fbca8…

Hi, [image] huxinjie0316: flash_log.txt (450.5 KB) It is not a serial console log. Please follow the above link to capture the log. Thanks

Hello, I tried installing the Ubuntu system today and then installed the NVIDIA SDK manager on Ubuntu using the script you provided. The installation was successful. Previously, it was installed under Windows using WSLs and SDK managers. I am not sure if there is a difference between these two metho…

Error occurred while flashing JetPack using NVIDIA SDK Manager

Robotics & Edge Computing Jetson Systems Jetson Thor

DavidDDD September 9, 2026, 11:45am 20

Hi,

Please refer to the related topics

The sdk manager flash failed because you might change the eeprom value.

Thanks

Topic		Replies	Views
Failed to flash Thor by SDK Manager Jetson Thor sdkm , flash	3	210	November 7, 2025
Failed in flash jp_7 to Thor Jetson Thor reflash , board-design	1	230	September 1, 2025
Unable to flash Thor module with custom carrier board Jetson Thor reflash , board-design	5	129	August 7, 2026
jetpack7.1,T5000,eeprom,flash failed Jetson Thor reflash	11	279	February 9, 2026
Custom carrier board design for Jetson Orin NX Jetson Orin NX board-design	12	461	June 18, 2025
Jetpack 4.6.2 and Jetson TX2 NX Jetson TX2 jetpack , board-design	3	1008	June 24, 2022
Flashing and Installing on Jetson Jetson Orin NX reflash	5	341	March 13, 2024
Flashing failed on JetPack 7.1 Jetson AGX Thor Jetson Thor boot	7	208	June 23, 2026
Flash to NVME fail on NX 8GB module Jetson Orin NX reflash , board-design	8	808	October 25, 2023
Using SDK Manager to Flash Jetson Thor on custom hardware Jetson Thor board-design , flash	1	106	February 27, 2026

Error occurred while flashing JetPack using NVIDIA SDK Manager

Related topics