Jetson Nano freezes after boot, says tegradc.1 error

[WayneWWW]

If the headless configuration really not appears in the end, you can try the debug script I shared long time ago…

A forum user verified this script still works last week.

Booting does not complete on Jetson Xavier NX & Quark Carrier - Please complete system configuration setup on the serial port provided by Jetson's

Please boot up/reboot device and try to hotplug the type C cable few times and see if anything comes from host dmesg. Also, please check if cdc_acm is listed in your host “lsmod”. If there is not, some methods here: method 1. Please directly contact Connecttech and ask them if their driver package missing some software so that you cannot do the system configuration. method 2. Try below script and re-flash the board again. It was a debug script I shared year ago. It shall skip the system con…