The MIPI clock voltage amplitude is too low

Hello, I am currently using a camera on the NX16 platform, and the measured MIPI clock signal is shown in the figure below. Its voltage amplitude is around 240-270mV. Is this voltage amplitude considered too low? Could you please let me know if there are any modifications in the device tree of the NX16 platform that can increase the MIPI signal amplitude? We have successfully increased the signal amplitude on other platforms by modifying voltage options in the device tree.

it looks duplicated with Topic 264284. let’s keep using original thread for following up.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.