Hello all,
I went into issues with TX2-NX + A203v2 carrier board. I bought and used the jetson tx +A203 v2 device carrier board about half a year ago and it went smoothly but yesterday I turned on the device the device lopping on the boot page, before that happened I tried to use the SD card for a place to run C ++ programs
Someone experienced same combo “Seeed A203v2 + TX2-NX” ?
Thanks,
Suggest to reflash the devcie with the provided SW by Seeed.
Finally i can reflash this device, but after reflash sdcard cannot detect
What step can I do
Please check with the vendor. We didn’t provide any TX2-NX BSP with sdcard enabled.
Sdcard cannot get detected after flashing sdkmanager is expected.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.
