Jetson TX2 is unresponsive after being turned on, CR5 and J2 are the only lights that are on (Green LEDs CR1 and CR2 off). Already tried putting the board in recovery mode, but my computer does not detect any usb device while it’s connected. Additionally, no HDMI output from Jetson. Has anyone experienced similar issues / have any trouble shooting steps I could take?
HDMI is not a reliable method to find out if a unit is not booting, but the lack of a recovery mode is good evidence of an actual failure. When in recovery mode, are you using the supplied micro-B USB cable? Is this the development kit, or is it a custom carrier board?