TX2 Shuts Off Immediately After Power-On

Robotics & Edge Computing Jetson & Embedded Systems Jetson TX2
, ,
1

I have a TX2 8GB that I have trouble getting to boot. When powered on, it displays

pca953x 0-074: failed reading register
pca953x 0-077: failed reading register
tegradc 152100000.nvdisplay: dc_hdmi_hotplug_init: couldn't get re
 vdd_hdmi_5v0, -517
FAN: couldn't get the regulator
ina3221x 0-042: ina3221 reset failure status: 0xffffff07
ina3221x 0-043: ina3221 reset failure status: 0xffffff07
 writing through dangling symlink 'etc/resolv.conf'
cgroup: cgroup2: unknown option "nsdelegate"
random: systemd: uninitialized urandom read (16 bytes read)
random: systemd: uninitialized urandom read (16 bytes read)
random: systemd: uninitialized urandom read (16 bytes read)
random: crng init done
random: 176 urandom warning(s) missed due to ratelimiting
CPU1: shutdown
CPU2: shutdown
Bridge firewalling registered

I am using a Leopard Imaging LI-TX1-CB carrier board.

3

Use serial console log to check the status. Do not relying this thing printed on monitor.

What you shared is just some common logs that exist even in normal boot situation.

5

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.